Page 1 of 1
Erjv2. Help!
Posted: 06-14-2014 10:41 AM
by Kyle David
Hello I have an issue with my erjv2 addon. During flight when I engage the autopilot and if I use LNAV or HDG select it over banks the airplane whenever I hit turbulence. Sometimes it seems the Autopilot is soo unstable and it has knocked the airplane into a very steep bank and has put it upside down. When I disengage the AP all is fine when I hand fly it but the AP keeps doing that . I'm not sure if its due to the fps or the turbulence or both. I'm using fs9. Everything else on the erjv2 is fine however.
Thank you
Kyle
Re: Erjv2. Help!
Posted: 06-15-2014 11:27 PM
by Theodore Martin
Kyle,
I assume that is the FeelThere ERJ which I have but I fly it in FSX. I have never experienced the problem you describe but I did look at the panel and documentation which discusses a BNK button. I have never used this button but the docs say it is a Bank Limiter. It's worth trying if you have not already done so. Also I assume you enable the Flight Director (FD button). The docs indicate the autopilot will not function properly without it being enabled.
Just some suggestions of things to try...
Re: Erjv2. Help!
Posted: 06-16-2014 08:48 AM
by Kyle David
Hello thank you for your response. Actually yes I am using the bank limiter and fd and when I change my headings if there is turbulence my bank exceeds and the airplane gets knocked into a steep bank. Same with LNAV. That's literally the only thing everything else I have no complaints.
Kyle
Re: Erjv2. Help!
Posted: 06-17-2014 05:15 PM
by Kyle David
Thank you all for your help. Yes, I had the joystick axes disconnected button clicked. I'm thinking maybe it was the turbulence speed i could have been overspeeding it I guess. I will try to find a way around it. thank you all again for trying to help
Kyle.