New Computer, New issues...

Here's the place to post technical questions about computer systems, optimal performance, hardware upgrades, and how to set the clock on your VCR.

Moderators: Michael Blakely, Todd Meek

User avatar
Wayne Pierce
Screenshot Contest Winner x24
Screenshot Contest Winner x24
Posts: 2225
Joined: 11-13-2007 11:09 PM
Position: DFWT-Manager Chief Check pilot
Rank: Commander
Hub: KPHX
Residence: San Diego, (South County) KSEE
AAV Total Hours: 2953.1
Previous VA Hours: 0
Current Bid: COMPLETED KPHX-KSFO
COMPLETED KSFO-KSEA
ASA3376 KSEA-KTUS
AAL455 KTUS-KPHX






Location: USA
Contact:

Re: New Computer, New issues...

Post by Wayne Pierce »

Sergio, gee, that is too bad.

Some things I have done to get rid of problems with the confuser and the FS programs. It sounds like your computer is trying to perform a windows function and stops the FS program to do it.

;If you use FSUIPC make sure the auto save function is set to off.
;Stop all virus programs and try the simulator. Mcafee and Norton do not like what we do. The Microsoft essentials works well, but windows 10 does not use it, only MS defender.
; If you are using WIN10 with FS... too bad. Certain combinations of your hardware do not agree on the same things.
; Start the computer with only the bare essentials activated. Only those programs needed to operate the computer. No extra stuff that you always had loaded and used.
;I have found in the past that the MSFS does not like the newest drivers for your graphics card, I had to roll back to an older driver to get it too work Which one do you use Nvidia? or the other brands you preferred.
:It doesn't matter if you use MSFS or LMP3DV3.4, if the computer may still want to do things on its own anyway.
;Try without any tweaks to the CFG file. If it works better then tweak up from there.
;Get a new computer. OH, it is. :wink:

Good luck fella.

Wayne
User avatar
Theodore Martin
Screenshot Contest Winner x10
Screenshot Contest Winner x10
Posts: 2865
Joined: 04-09-2005 08:51 AM
Position: DFW Hub Manager
Rank: Commander
Hub: KDFW
Residence: Dallas, TX
AAV Total Hours: 3185.8
Previous VA Hours: 0
Current Bid: Awaiting Bid

Re: New Computer, New issues...

Post by Theodore Martin »

Sounds all too familiar. This is the problem I had when Microsoft in their "wisdom" automatically upgraded my computer to Win 10. I tried everything...rebuilding my CFG file, tweeking settings, all versions of Automationcore, and more. I only use Microsoft Essentials for virus protection (which was replaced by Microsoft Defender) so I don't think antivirus had anything to do with it, and I can't say for sure but I think I even disabled it at one point as a test. I searched the Internet for solutions and found only one potential solution that would have required a complex change to a Windows file (Opencl_dll reported an error if you ran a specific utility file) and after further investigation I felt this was not the issue.

I did find that rolling back my Nvidia graphics driver to the version I previously used seemed to help (changed interval of lockups) but did not eliminate the problem. I also found that Windows 10 kept updating my driver no matter how often I rolled it back or attempted to keep it from updating.

Good luck finding the problem and when you do please tell us your resolution.
Theodore "Ted" Martin
DFW Hub Mgr.
AAV537
Image
ImageImage

Image
User avatar
Michael Blakely
Screenshot Contest Winner x7
Screenshot Contest Winner x7
Posts: 3796
Joined: 07-21-2003 01:14 PM
Position: CEO
Rank: Commander
Hub: KDCA
Residence: San Diego (North County)
AAV Total Hours: 3485.5
Previous VA Hours: 0
Current Bid: COMPLETED KJFK-KDFW
COMPLETED KDFW-KIAD
COMPLETED KIAD-KDFW
AAL2248 KDFW-KSFO
ASA915 KSFO-KSEA
ASA672 KSEA-KDEN
AAL2771 KDEN-KORD
AAL1918 KORD-KPHX
AAL1945 KPHX-KDFW
AAL2437 KDFW-KLAX
Contact:

Re: New Computer, New issues...

Post by Michael Blakely »

I had the MD-11 freeze for 10 minutes at a time, but it occurred about once every 50 minutes, not 5. After making several changes to fix this, I noticed the most improvement when I set my frame rates to "unlimited" instead of trying to lock to a specific value.

I also agree with the suggestion you may need to roll back your graphics driver version.

I was reading this weekend about how PMDG stopped selling and supporting the MD-11 in 2016 due to the effort it took to support Win-10 drivers. I know I'll need to move off Win 7 someday. It's kind of sad to know my MD-11 days are numbered.
Mike

Image
Bid Theme: Back in the USA
Image
User avatar
Michael Blakely
Screenshot Contest Winner x7
Screenshot Contest Winner x7
Posts: 3796
Joined: 07-21-2003 01:14 PM
Position: CEO
Rank: Commander
Hub: KDCA
Residence: San Diego (North County)
AAV Total Hours: 3485.5
Previous VA Hours: 0
Current Bid: COMPLETED KJFK-KDFW
COMPLETED KDFW-KIAD
COMPLETED KIAD-KDFW
AAL2248 KDFW-KSFO
ASA915 KSFO-KSEA
ASA672 KSEA-KDEN
AAL2771 KDEN-KORD
AAL1918 KORD-KPHX
AAL1945 KPHX-KDFW
AAL2437 KDFW-KLAX
Contact:

Re: New Computer, New issues...

Post by Michael Blakely »

Excellent!
Mike

Image
Bid Theme: Back in the USA
Image
Harold Henderson
Screenshot Contest Winner x13
Screenshot Contest Winner x13
Posts: 6550
Joined: 08-07-2005 10:00 PM
Position: KPHX Hub Manager
Rank: Commander
Hub: KPHX
Residence: Knoxville, TN
AAV Total Hours: 3600.3
Previous VA Hours: 0
Current Bid: COMPLETED KPHX-KMCI
COMPLETED KMCI-KLAS
COMPLETED KLAS-KAUS
AAL3830 KAUS-KRDU
AAL891Q KRDU-KMIA
AAL1397 KMIA-KMCI
AAL1622 KMCI-KPHX



Contact:

Re: New Computer, New issues...

Post by Harold Henderson »

Sergio Sanchez wrote:ok... so I updated the audio drivers per an AVSIM post in the PMDG forums...
Was this related to the particular audio chip or card you're using? Post a link to the article. Might help others.
Wisdom begins when you finally realize someone else is in charge of the universe.
ImageImage

VATSIM Flight Tracking Info
User avatar
Norberto Rivera
Screenshot Contest Winner x7
Screenshot Contest Winner x7
Posts: 6355
Joined: 10-10-2004 05:18 PM
Position: CLT Commander Extraordinaire
Rank: Commander
Hub: RETIRED
Residence: Sterling, VA
AAV Total Hours: 2667.4
Previous VA Hours: 0
Current Bid: COMPLETED KPSP-KDFW
COMPLETED KDFW-KSHV
COMPLETED KSHV-KDFW
AAL2731 KDFW-KPSP






Re: New Computer, New issues...

Post by Norberto Rivera »

Sergio Sanchez wrote:Harold, I updated my Realtek drivers... Heres the link to the AVSIM post.

http://www.avsim.com/topic/432227-8-min ... -solution/

Currently I'm flying my beloved MD11 back to DFW... I'll post my landing rate (hopefully) in a few hours...

***** and... lockup... :cry:

Wow! You mean your landing rate was so high you locked up your computer??? Now THAT takes talent! Hats off to you mijo! :lol: :lol: :lol:

Hope you get it worked out soon. I'm sorry I can't think of any suggestions. I tried Win10 but rolled my machine back to Win7 after just a weekend.
Norberto "Bert" Rivera
AAV476
"The knack of flying is learning how to throw yourself at the ground and miss"
"I'm not a real pilot, but I play one on VATSIM"
"If at first you don't succeed, skydiving is not for you."
"Sarcasm is just one more service I offer"

Current bid theme: Random Airbus Bid
Image
Image
Check out my aircraft pics on Flightaware.
User avatar
Tom Pletzke
Screenshot Contest Winner x4
Screenshot Contest Winner x4
Posts: 1433
Joined: 06-01-2005 10:36 PM
Position: Miami Hub Manager
Rank: Commander
Hub: RETIRED
Residence: Michigan
AAV Total Hours: 1456.1
Previous VA Hours: 0
Current Bid: COMPLETED KORD-KCLT
COMPLETED KCLT-KLAX
COMPLETED KLAX-KCLT
COMPLETED KCLT-TIST
AA803 TIST-KCLT
AA2039 KCLT-KTPA
AA712 KTPA-KDCA
AA899 KDCA-KFLL
AA447 KFLL-KCLT
AA622 KCLT-KORD
Location: Michigan
Contact:

Re: New Computer, New issues...

Post by Tom Pletzke »

With a new computer, I would use new software. Try X-Plane. I think the graphics really excel on the new computers. I think there is a new version coming out that I know I will be getting. I use X-Plane now and it is very good. I know you probably infested a lot of money in FSX but I would at least give it a look.
Tom Pletzke
AAV558
Miami Hub Manager
American Airlines Virtual

Tom Pletzke Tracking Vatsim Info
Image
User avatar
Michael Blakely
Screenshot Contest Winner x7
Screenshot Contest Winner x7
Posts: 3796
Joined: 07-21-2003 01:14 PM
Position: CEO
Rank: Commander
Hub: KDCA
Residence: San Diego (North County)
AAV Total Hours: 3485.5
Previous VA Hours: 0
Current Bid: COMPLETED KJFK-KDFW
COMPLETED KDFW-KIAD
COMPLETED KIAD-KDFW
AAL2248 KDFW-KSFO
ASA915 KSFO-KSEA
ASA672 KSEA-KDEN
AAL2771 KDEN-KORD
AAL1918 KORD-KPHX
AAL1945 KPHX-KDFW
AAL2437 KDFW-KLAX
Contact:

Re: New Computer, New issues...

Post by Michael Blakely »

Tom Pletzke wrote:With a new computer, I would use new software. Try X-Plane. I think the graphics really excel on the new computers. I think there is a new version coming out that I know I will be getting. I use X-Plane now and it is very good. I know you probably infested a lot of money in FSX but I would at least give it a look.
...but.... then we would have no PMDG MD-11 (sniffing back tears) :(

I totally get where Sergio is coming from. I loved the RFP 747-200 in FS9. So many systems on an older, less automated plane. I hated to give that one up, but eventually the lure of FSX scenery overcame the time it took to keep both FS9 and FSX up to date.

I"ll feel the same way when I lose the MD-11 to the march of time and technology.

I put my hope in future technology when I can fly ANY plane on an awesome simulator (think start trek holo deck).
Mike

Image
Bid Theme: Back in the USA
Image
Rey Ramon
Screenshot Contest Winner x1
Screenshot Contest Winner x1
Posts: 1881
Joined: 12-06-2002 07:01 PM
Position: A Senior Pilot
Rank: Commander
Hub: KPHL
Residence: Wilmington, DE
AAV Total Hours: 2588.9
Previous VA Hours: 0
Current Bid: COMPLETEDAAL1441 KPHL-KRDU
AAL174 KRDU-EGLL
BAW496 EGLL-LEPA
CHARTER LEPA-LEBL
CHARTER LEBL-LIRQ
BAW521 LIRQ-EGLL
AA737 EGLL-KPHL



Re: New Computer, New issues...

Post by Rey Ramon »

OMG I've been away for too long! What the heck is Automationcore?!?!!??! And what more...why am I still awake this late. Not gonna want to wake up in the morning for work. On the plus side, I've reactivated my Vatsim Account!!!
Post Reply